Installation Guide

Clean the Watch Surface

Using the included microfibre cloth, gently wipe all surfaces of the watch to remove any dust, fingerprints, or debris. Ensure the surface is completely clean before proceeding.

Apply the Solution

Lightly spray the provided application solution onto all applicable watch parts. Wipe thoroughly with the microfibre cloth to ensure the surface is primed and free from any residue.

Prepare the Protection Film

Using the provided tweezers, carefully remove the first piece of protection film from its backing. Lightly spray both sides of the film with the application solution to activate its adhesive properties.

Position and Apply the Film

Carefully align the film piece with its corresponding watch surface. Once correctly positioned, apply firm and even pressure to bond the film and push out any trapped solution. Allow the piece to rest in place for 20–30 seconds.

Squeegee Out Excess Solution

Using your finger, gently push from the centre outward to remove any remaining solution or air bubbles trapped beneath the film.

Allow to Dry

Leave the applied film piece to dry naturally for up to 2 minutes before moving on to the next piece. Avoid disturbing the film during this time.

Repeat for All Remaining Pieces

Follow the same process for each remaining piece in your kit, working methodically until all protection film pieces have been applied to your watch.